MIL-PRF-1/1400D
TABLE I. Testing and inspection - Continued.
7/
Line width "B" shall be measured at 1.6 inches (40.6 mm) from the undeflected spot position for guns A and B and at .8 inch
(20.3 mm) for gun C. The test shall then be repeated for guns A and B with the roles of horizontal and vertical plates
reversed so that measurements shall be made at 5 points for each gun; center, 1.6 inches (40.6 mm) to right and left of
center, and 1.6 inches (40.6 mm) above and below center.
8/
Each spot shall fall within a circle of .438 inch (11.11 mm) radius, centered about the specified spot position (see figure 2.)
9/
The 1D2 deflection factor of each gun shall be within 5 percent of that of the other guns.
10/
The useful scan of each gun shall be as shown on figure 2.
11/
The trace from each gun, when deflected with a rectangular raster so that its widest points just touch the outside rectangle as
shown on figure 3, shall fall entirely within the outside rectangle, but entirely outside the inscribed rectangle. Note that the
horizontal trace from gun A, when passing through the tube face center, and when deflected to the full useful width, falls
entirely within a rectangle 6.95 inches (176.5 mm) wide and .062 inch (1.57 mm) high.
12/
Test shall be performed at the conclusion of the holding period.
13/
Inspection shall be 100 percent.
14/
This specification sheet uses accept on zero defect sampling plan in accordance with MIL-PRF-1, table III.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business