MIL-DTL-75K
ASTM INTERNATIONAL
ASTM-D1974
-
Methods of Closing, Sealing, and Reinforcing Fiberboard Boxes (DoD
adopted).
ASTM-D3951
-
Commercial Packaging (DoD adopted).
ASTM-D3953
-
Strapping Flat Steel and Seals (DoD adopted).
ASTM-D4727/D4727M -
Corrugated and Solid Fiberboard Sheet Stock (Container Grade) and
Cut Shapes (DoD adopted).
ASTM-D5118/D5118M -
Fabrication of Fiberboard Shipping Boxes (DoD adopted).
ASTM-D6251/D6251M -
Wood-Cleated Panelboard Shipping Boxes (DoD adopted).
ASTM-D5168
-
Fabrication and Closure of Triple Wall Corrugated Fiberboard
Containers (DoD adopted).
ASTM-D6880
-
Wood Boxes.
(Copies of these documents are available online at https://www.astm.org or from ASTM International,
100 Barr Harbor Drive, West Conshohocken, PA 19428-2959.)
NATIONAL CONFERENCE OF STANDARDS LABORATORIES (NCSL)
NCSL-Z540.1
-
Calibration Laboratories and Measuring and Test Equipment (DoD
adopted).
(Copies of the above document are available online at https://www.ncsli.org or from National Conference of
Standards Laboratories (NCSL), 2995 Wilderness Place Suite 107, Boulder, CO 80301-5404.)
2.4 Order of precedence. In the event of conflict between the text of this document and the references
cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes
applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 General. The packaging terms used herein shall be in accordance with the definitions listed in
MIL-STD-2073-1.
3.1.1 Pairs and sets. Electron tubes furnished in pairs or sets under one national stock number (NSN)
shall be unit packed as one pair or one set, as applicable. When individual unit packs are used to make
up a pair or set of tubes, they shall not be taped or glued together but shall be enclosed within a close
fitting, unit container.
3.1.2 Hardware. Hardware accompanying electron tubes shall be protected and enclosed within the
unit packs in a manner that will not damage the electron tubes or packaging materials. When practical,
the hardware should be mounted on each electron tube.
3.1.3 Physical protection. Electron tubes and accessories shall be packaged in a manner that will
ensure compliance with applicable requirements of MIL-STD-2073-1 as well as those specified herein.
3.1.3.1 Pins, leads, terminals, and waveguide mounting surfaces. Pins, leads, terminals, and other
outward projections shall be protected by means of container design or non-corrosive die-cut inserts or
other suitable supporting materials or devices. Waveguide mounting surfaces shall be protected with
tight-fitting plastic covers, caps, or other suitable protective materials.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business