MIL-DTL-75K
4.7.2 Functional inspections.
4.7.2.1 Rough handling. Packs shall be subjected to the applicable rough handling tests and the
interpretation of results or cause for rejection as specified in MIL-STD-2073-1, Appendix G, Appendix F,
and 3.5.1.1 herein. The upper corner drops of the free fall drop test shall not be required for those tubes
that cannot be inverted without internal damage.
4.7.2.2 Leakage. When a waterproof or water vapor-proof barrier is required, the unit pack shall be
subjected to the applicable leakage test and interpretation of results specified in MIL-STD-2073-1,
Appendix G, G.4.2, and 3.5.1.2 herein.
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the
contract or order (see 6.2). When actual packaging of materiel is to be performed by DoD or in-house
contractor personnel, these personnel need to contact the responsible packaging activity to ascertain
packaging requirements. Packaging requirements are maintained by the Inventory Control Point's
packaging activities within the Military Service or Defense Agency, or within the military service's system
commands. Packaging data retrieval is available from the managing Military Department's or Defense
Agency's automated packaging files, CD-ROM products, or by contacting the responsible packaging
activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not
mandatory.)
6.1 Intended use. The preservation, packing, and marking specified herein are intended for direct
shipments to the Government. However, this specification may also be used for the preparation of
electron tubes and accessories for shipment from parts contractor to the original equipment
manufacturer.
6.2 Ordering data. Acquisition documents should specify the following:
a. Title, number, and date of this specification.
c. Methods of preservation, if other than that specified (see 3.2.4.3 and 3.2.4.4).
d. If magnetic shielding is required (see 3.2.4.3).
f.
If a unitized load is not required for shipment to one destination when total quantities are equal
to 40 cubic feet or more (see 3.3.4).
g. If other identification marking or special marking is required (see 3.4).
13
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business