MIL-PRF-1/126F
TABLE I. Requirements and tests - Continued.
Limits
MIL-STD-1311
Requirement or test
Type
Conditions
Symbol
Unit
method
Min
Max
Conformance
inspection, part 3
1501
a, b
Group A;
---
---
---
---
Intermittent life
Eb = Ec2 = 300 V dc;
Ec1 = -20 V dc;
Ehk = 100 V
---
a, b
Power output
Po
2.3
---
W
Life-test end point
(intermittent) (500 hours)
NOTES:
1. The base shall be one of the following: B6-81, B6-84, B7-7, B7-59, or B8-251.
2. This test to be performed at the conclusion of the holding period.
3. The rejection level shall be set at the VU meter reading obtained during calibration.
4. This test applies for flexible leads as well as for rigid leads.
Referenced documents. In addition to MIL-PRF-1, this document references MIL-STD-1311.
The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This
was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations.
Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the
marginal notations and relationship to the last previous issue.
Custodians:
Preparing activity:
Army - CR
DLA - CC
Navy - EC
Air Force - 85
(Project 5960-2013-002)
DLA - CC
Review activities:
Army - AR, AV, MI
Navy - AS, CG, MC, OS, SH
Air Force - 19, 99
NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and
responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business